Sound Troubleshooting Guide – Carrier Enterprise Technical Services & Support

Por favor, activa JavaScript en tu navegador para completar este formulario.

– Paso 1 de 4

Before this sound troubleshooting guide is used

Conduct a full verification of system performance in accordance with the installation instructions.
This includes, but is not limited to, confirming:
Correct refrigerant charge
Proper indoor airflow
Appropriate voltages and electrical conditions
Any other performance metrics required by the installation manual
The troubleshooting steps in the guide below were written with the assumption that system performance has already been fully verified.
Please note that a Sound Complaint Checklist must be submitted along with this Sound Troubleshooting Guide.

When should this sound troubleshooting guide be used

Operate the unit under the same conditions in which the customer-reported noise occurs.
If the noise is not steady, constant, and repeatable, this guide may not apply.
Transient noises—such as those caused by a reversing valve, contactor engagement, or TXV chatter—must be identified and resolved before completing this checklist. These short‑duration sounds are not considered steady operational noise and should be addressed separately.

Guardar y reanudar más tarde

CASE INFORMATION

Por favor, selecciona tu región. *

Select the region where the job is located so this sound troubleshooting request routes to the correct Technical Service & Support team.

Nombre del concesionario / empresa *

Dealer/contractor servicing the system.

Número de cuenta del distribuidor

Dealer/contractor account number.

Nombre del técnico *

Name of technician submitting the sound troubleshooting report.

Técnico de teléfonos celulares *

Mobile phone number of the technician submitting the report.

Correo del técnico *

A copy of this submission will be sent to this email address.

Número de serie de la unidad exterior *

Número de modelo de la unidad exterior *

What type of sound best describes the complaint? *

Vibration
Rattle
Buzzing
Humming
Pulsing
Whistling
Grinding
Compressor tonal sound
Otro

When does the sound occur? *

Startup
Shutdown
Continuous operation
Cooling mode
Heating mode
Defrost
Specific outdoor temperature
Otro

Where is the sound most noticeable? *

At outdoor unit
Inside the home/building
Near line-set penetration
Near indoor unit
Through ductwork
Neighboring property / exterior wall
Otro

Is the sound steady, constant, and repeatable under the same operating conditions? *

This guide works best for steady, constant, repeatable operational sounds.

If the sound is not steady, constant, and repeatable, describe when it occurs. *

Transient sounds may need separate diagnosis. Provide as much detail as possible.

Guardar y reanudar más tarde

FOLLOW THE GUIDE BY COMPLETEING & ANSWERING EACH POSTED QUESTION

Turn the unit off. And disconnect compressor from the contactor. *

Done

Turn the unit on, and operate the outdoor fan motor only.

With the compressor disconnected: is the complaint still present? *

Turn unit off.

Disconnect the fan motor. Reconnect the compressor to the contactor. *

Done

Turn the unit on, operating only the compressor.

With the fan disconnected: is the complaint still present? *

Turn the unit off.

Reconnect the outdoor fan motor to the contactor. Turn the unit on. *

Done

Motor Vibration

Feel the motor plate & side of the unit’s top cover

a) Motor plate vibration indicates possible fan misalignment
b) Side edge vibration indicates blade imbalance.

Is the motor plate vibrating more than the side edge of the top cover? *

Condenser fan blade

After replacing the fan blade, is the complaint still present? *

Complaint still present

Replace the condenser fan motor. *

Done

Fan blade position

a) Shift position of the fan blade up on the shaft.

b) Ensure that the fan blade will still rotate freely.

After adjusting fan blade position, is the complaint still present? *

Turn the unit off.

Reconnect the outdoor fan motor to contactor. *

Done

Turn unit on

Listen to the noise from inside the house.

Is the noise worse inside than outside? *

Noise origin

Does the noise seem to be coming from the line set itself? *

Install an inline liquid line muffler.

After installing an inline liquid line muffler, is the complaint still present? *

Line set vibration

Does the noise seem to be coming from the line set vibrating against a wall or duct? *

Isolation hangers

Use isolation hangers near the point(s) of contact to reduce the vibration.

After installing isolation hangers, is the complaint still present? *

Source of the noise

Does the noise seem to be coming through the ductwork or directly from the indoor unit? *

Indoor unit

Diagnose and replace the indoor unit component causing the noise. *

Done

Chassis or accessory noise

Does the noise seem to be coming from a rattling grille, panel, or louver? *

Unit fasteners and level

Verify all screws are tight and the unit is level.

After verifying fasteners and unit level, is the complaint still present? *

Unit chassis shifting

Apply sideways pressure to the unit, slightly lifting base pan off its support.

Does applying sideways pressure to the unit affect the complaint? *

Rubber isolation pads

Place rubber isolation pads under the base pan on all four corners of the unit.

After installing rubber isolation pads, is the complaint still present? *

Service valves / lines isolation

a) Remove the four (4) mounting screws to release both service valves from the base pan.

b) Apply pressure on the line-set between the unit and the wall pass-through

Does isolating the service valves / lines affect the complaint? *

Line – mass damper

Place rubber mass damper on the line-set between the unit and the wall pass-through.

With the mass damper installed, is the complaint still present? *

Orientation & connection

Which diagram above best describes the application? *

Extending refrigerant piping

Rotate the unit 90° and extend piping. *

Done

Application A will be rotated CCW to end up as C. Application B on the other hand must be rotated CW to end up as D.

With the unit rotated, is the complaint still present? *

Compressor support

a) Turn the unit off

b) Release the compressor feet from the base pan by removing the four (4) mounting screws

Release compressor support. *

Done

Turn unit on

Did releasing the compressor screws affect the complaint? *

Changing grommets

a) Turn unit off

b) Change to split-post compressor grommets [order 4 @ KA75UG100]

Replace compressor grommets. *

Done

New split-post grommets

Turn unit on

With new grommets, is the complaint still present? *

Re-torque compressor bolts

Factory spec. for compressor bolt is 90 in-lb

Re-torque compressor bolts. *

DONE

Sound shield/blanket

a) Turn unit off

b) Install sound shield. Review product data for the unit for the correct accessory part number for the unit

If a sound shield/blanket is already installed, change to the miter box model

Install sound shield / sound blanket. *

Done

Turn unit on

With sound shield installed, is the complaint still present? *

Replace the compressor

After completing this sound troubleshooting guide, the manufacturer’s recommendation is to replace the compressor in this unit.

Compressor replacement recommendation acknowledged. *

Acknowledged

Guardar y reanudar más tarde

Required troubleshooting photos *

Arrastrar y soltar archivos, Elija los archivos para cargar Puedes subir hasta 8 archivos.

Upload clear photos of the outdoor unit data tag, unit placement, line-set routing, service valve area, compressor mounting area, fan blade/motor area, and any installed sound accessories.

Required sound video/audio *

Arrastrar y soltar archivos, Elija los archivos para cargar Puedes subir hasta 3 archivos.

Upload a video or audio file that captures the reported sound under the same operating conditions.

Final notes / suspected source of sound *

Include any additional observations, corrective actions taken, or suspected source of the sound.

Revisión final

Technical Support will review the submitted sound troubleshooting information. Upload the required photos and sound video/audio before submitting.

Sound Complaint Checklist requirement acknowledged. *

Acknowledged

Complete any required Sound Complaint Checklist process used by your team and acknowledge before submitting.

Correo electrónico

Guardar y reanudar más tarde

Tu entrada del formulario ha sido guardada y se ha creado un enlace único al que puedes acceder para reanudar este formulario.

Enter your email address to receive the link via email. Alternatively, you can copy and save the link below.

Tenga en cuenta que este enlace no debe compartirse y caducará en 30 días, después de lo cual su entrada de formulario será eliminada.

Copiar enlace

Correo electrónico *